The Atelier HandbookFaden help centre

Tech packs: the cut sheet your maker reads

Cutter or makerOwner 1 min read · updated · checked against the app
In short

What's on the sheet, how to shape the template to your factory, and why good posture notes save remakes.

On this page

The tech pack is the single document production works from. If it's right, the garment usually is.

What's on it

  • Measurements: the client's current set, in your units.
  • The design: garment, options, construction choices, monogram and lining details.
  • Cloth: the fabric, and quantity where yield applies.
  • Maker notes: posture observations and instructions from fittings, in the tailor's words.

Shaping the template

Settings → Production & fit → tech-pack templates controls the sheet's sections and order. Factories have habits, and the sheet should match how yours reads a job, not fight it. Different templates suit different makers.

The notes matter most

A measurement says what; a note says why: "right shoulder low, ease through the seat, client dislikes high armholes". That's the difference between a first fitting and a third. Capture them at the rail (Fitting mode) and they ride the sheet automatically.

With client masking on, the sheet identifies the job by number, not name, so your client list stays yours. See Data Control.

Did this get you there?

Still stuck?

A person reads every message.

support@faden.techWe reply by email Service statusAll systems running