The Atelier HandbookFaden help centre

Recording measurements

OwnerFront of house 2 min read · updated · checked against the app
In short

Versioned measurement sets, fitting mode for appointments, units, and the checks Faden runs before anything goes to production.

On this page

Measurements in Faden are versioned. Every set is kept, so you can see how a client has changed and roll back if a new set looks wrong.

Where they live

Open a client record and choose the Fit tab. Add a set by hand, or capture one live in a fitting.

Fitting mode

Press the scissors button (Fitting mode) in the top bar during an appointment. It's a full-screen, tap-first capture flow built for standing next to a client with a tape: big targets, one measure at a time, guides for each point.

Units and standards

Choose metric or imperial in Settings → Production & fit. The same section controls your sizing standard and which measurements are mandatory before production. Faden will hold a commission rather than dispatch a cut sheet with gaps.

Faden watches the numbers

When a new set differs sharply from the last one, the record flags it. That catches typos and real changes (weight trend, posture) before they reach the factory.

Clients can help

Clients can see their measurements in their portal and add a set of their own. A set a client adds is saved straight to their record as a new version. There is no approval step, so check it before you cut.

Did this get you there?

Still stuck?

A person reads every message.

support@faden.techWe reply by email Service statusAll systems running